There are many ceiling lamps in the home, so what do we need to pay attention to when installing the ceiling lamps?

Ceiling lamp installation precautions:

1. When installing the ceiling lamp in the masonry structure, the embedded bolts should be used, or fixed with expansion bolts, nylon plugs or plastic plugs. Wood wedges should not be used. And the bearing capacity of the above-mentioned fixing member should be matched with the weight of the ceiling lamp to ensure that the ceiling lamp is fixed firmly and reliably, and the service life thereof can be prolonged.

2. When fixing with expansion bolts, the bolt specifications should be selected according to the technical requirements of the product. The drilling diameter and the buried depth should be consistent with the bolt specifications.

3. The number of fixed lamp holder bolts should not be less than the number of fixing holes on the base of the lamp, and the diameter of the bolts should match the hole diameter; the lamps with no fixed mounting holes on the base (self-punching during installation), each fixture is used for fixing The number of bolts or screws should not be less than 2, and the center of gravity of the lamp should match the center of gravity of the bolt or screw; only when the diameter of the insulation table is 75mm or less, it can be fixed by one bolt or screw.

4, ceiling lamps can not be directly installed on flammable objects, some families for the appearance of paint after the three plywood lining behind the ceiling lamp, in fact, this is very dangerous, must take thermal insulation measures; if the surface of the lamp is near the flammable high temperature Insulation or heat dissipation measures should also be taken.

5. The ceiling lamp should also be checked before installation:

The cross section of the wire core leading to each luminaire, the copper core cord is not less than 0.4mm?, the copper core is not less than 0.5mm?, otherwise the lead must be replaced.

The connection between the wire and the lamp cap, the connection of the parallel wires between the lamp caps should be firm, and the electrical contact should be good, so as to avoid sparks between the wires and the terminals due to poor contact, and danger occurs.

6. Educate children not to throw balloons and other objects into the lamps indoors, so as to prevent the decorations hanging on the lamps from falling and injuring people or affecting the decorative effect of the lamps.