Fire emergency lights After we buy them back, we also need regular inspection, care, maintenance, etc., then how to operate the fire emergency lights installation and maintenance?

1. The characteristics of various wiring methods should be accurately mastered, otherwise the speculative wiring should not work.

2. If the emergency lighting is used as a small part of the daily lighting, a three-wire control connection should be used.

3. For multi-storey high-rise public buildings, if a control center is set up, different parts of fire emergency luminaries can be operated with local power switch (single light single control or multiple light control) or centralized control system in power distribution cabinet. Three-wire connection.

4. There is a fire control center project. In order to meet the fire accident, the control center can activate the fire accident layer and the relevant layer fire safety emergency lighting requirements.

Installation and maintenance of fire emergency lights:

1. In the construction engineering design, in order to facilitate daily maintenance and management, the fire emergency lighting is preferably powered by a common feeder control loop.

2. In order to ensure the safety and reliability of the fire safety emergency lighting power supply system, the power supply system of the low voltage emergency bus section of the substation should be conditionally, that is, when the diesel generator set is used as the emergency power supply, if the generator set is put into use, it There is electricity to continue to provide power.

3. In the case of fire accidents, there is less smoke and more oxygen on the ground. The instinctive reaction of people's fire escape is to bend or squat forward, so that the local high-illumination lighting fixtures are higher than the high ones.